Supermicro X11SCV-Q - Page 86

Super X11SCV-Q/-L User's Manual
86
• Software Preserve Support
Serial ATA Port 0-4 Hot Plug
Set this feature to Enable for hot plug support, which will allow the user to replace a SATA
drive without shutting down the system. The options are Disabled and Enabled.
Serial ATA Port 0-4 Spin Up Device
Set this feature to enable or disable the PCH to initialize the device. The options are
Disabled and Enabled.
Serial ATA Port 0-4 SATA Device Type
Use this feature to specify if the SATA port specied by the user should be connected to a
Solid State Drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
PCH-FW Conguration
ME Firmware Version
ME Firmware Mode: Normal Mode
ME Firmware SKU: Corporate SKU
ME FW Image Re-Flash
Use this feature to update the Mangement Engine rmware. The options are Disabled and
Enabled.
Manageability Features State
Enabled this feature to allow system administrators to congure the ME BIOS extension
(MEBx) conguration settings. The options are Disabled and Enabled.
AMT BIOS Features
Disable this feature to deny access to the MEBx setup. The options are Disabled and Enabled.
*If the feature "AMT BIOS Features" is set to Enabled, the AMT Conguration submenu
will be available for conguration:
AMT Conguration
ASF support
Use this feature to enable or disable Alert Standard Format support. This feature sends an
alert about a potential issue when the operating system is in a sleep state. The options are
Disabled and Enabled.