Supermicro X11SCW-F - Quick Reference Table

12
Super X11SCW-F User's Manual
Quick Reference Table
Jumper Description Default Setting
JBT1 CMOS Clear Open (Normal)
JPG1 VGA Enable Pins 1-2 (Enabled)
JPL1, JPL2 LAN1, LAN2 Enable Pins 1-2 (Enabled)
JPME2 ME Manufacturing Mode Pins 1-2 (Normal)
JWD1 Watchdog Timer Pins 1-2 (Reset)
LED Description Status
LE1 Unit Identier (UID) LED Solid Blue: Unit Identied
LE6 Power Ready LED
Solid Amber: Standby
Solid Red: Power Failed
Solid Green: Power On
LEDEC1 Embedded Controller (EC) Heartbeat LED Blinking Green: EC Normal
LEDEC2 EC Thermal Event LED Solid Red: CPU/DIMM Overheat
LEDM1 BMC Heartbeat LED Blinking Green: BMC Normal
LEDPWR Onboard Power LED Solid Green: Power On
Connector Description
BT1 Onboard Battery
COM1, COM2 COM Port, COM Header
FAN1 ~ FAN6 CPU/System Fan Headers
IPMI_LAN Dedicated IPMI LAN Port
I-SATA2 ~ I-SATA7
Intel® PCH SATA 3.0 Ports (with RAID 0, 1, 5, 10)
I-SATA2 and I-SATA3 supports SuperDOM
I-SGPIO1, I-SGPIO2 Serial Link General Purpose I/O Headers
JD1
Power LED Indicator/Speaker Header
(Pins 1-3: Power LED; Pins 4-7: Speaker)
JF1 Front Control Panel Header
JIPMB1 4-pin BMC External I
2
C Header (for an IPMI card)
JL1 Chassis Intrusion Header
JPI
2
C1 Power I
2
C System Management Bus (SMB) Header
JPWR1 24-pin ATX Power Supply Connector
JPWR2 8-pin Power Connector
JSD1, JSD2 SATA DOM Power Connectors
JSTBY1 Standby Power Header
JTPM1 Trusted Platform Module (TPM)/Port 80 Header
LAN1, LAN2 1GbE LAN Ports
Notes: The table above is continued on the next page.