Supermicro X11SPH-NCTPF - Page 90

Super X11SPH-NCTPF/-NCTF User's Manual
90
PCH sSATA Conguration
When this submenu is selected, the AMI BIOS automatically detects the presence of the SATA
devices that are supported by the Intel PCH chip and displays the following items:
sSATA Controller
This item enables or disables the onboard sSATA controller supported by the Intel PCH chip.
The options are Enable and Disable.
Congure sSATA as
Select AHCI to congure an sSATA drive specied by the user as an AHCI drive. Select RAID
to congure an sSATA drive specied by the user as a RAID drive. The options are AHCI
and RAID.
SATA HDD Unlock
This feature allows the user to remove any password-protected SATA disk drives. The options
are Disable and Enable.
Aggressive Link Power Management
When this item is set to Enable, the SATA AHCI controller manages the power usage of the
SATA link. The controller will put the link in a low power mode during extended periods of I/O
inactivity, and will return the link to an active state when I/O activity resumes. The options
are Disable and Enable.
*If the item above "Congure sSATA as" is set to RAID, the following items will become
available for conguration:
sSATA RSTe Boot Info
Select Enable to provide full int13h support for the devices attached to sSATA controller. The
options are Disable and Enable.
sSATA RAID Option ROM/UEFI Driver
Select UEFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
sSATA Port 0 ~ Port 2
This item displays the information detected on the installed sSATA drive on the particular
sSATA port.
• Model number of drive and capacity
• Software Preserve Support