Supermicro X11SPH-NCTPF - Quick Reference Table

13
Chapter 1: Introduction
Note: Table is continued on the next page.
Quick Reference Table
Jumper Description Default Setting
JBT1 CMOS Clear Open (Normal)
JPS1 SAS 3.0 Enable/Disable Pins 1-2 (Enabled)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPME2 ME Manufacturing Mode Pins 1-2 (Normal)
JWD1 Watchdog Timer Pins 1-2 (Reset)
LED Description Status
DLE1 PCI-E 3.0 M.2 LED Blinking Green: Device Working
LEDBMC BMC Heartbeat LED Blinking Green: BMC Normal
LEDPWR Onboard Power LED Solid Green: Power On
LEDSAS SAS Activity LED
Blinking Green: SAS Active
Solid Red: SAS Error
UID LED Rear UID LED Blue On: Unit Identied
Connector Description
BT1 Onboard Battery
COM1, COM2 COM Port, COM Header
FAN1 ~ FAN5, FANA ~ FANC CPU/System Fan Headers (FAN1: CPU Fan)
IPMI_LAN Dedicated IPMI LAN Port
I-SATA0~3, I-SATA4~7 Intel® PCH SATA 3.0 Ports (with RAID 0, 1, 5, 10)
JD1 Power LED/Speaker Header (Pins 1-3: Power LED, Pins 4-7: Speaker)
JF1 Front Control Panel Header
JIPMB1 4-pin BMC External I
2
C Header (for an IPMI Card)
JL1 Chassis Intrusion Header
JNVI
2
C1 NVM Express (NVMe) I
2
C Header
JNVME1, JNVME2 NVMe PCI-Express 3.0 x4 Connectors
JOH1 Overheat LED Indicator
JPI
2
C1 Power I
2
C System Management Bus (SMB) Header
JPWR1 8-pin 12V CPU Power Connector
JPWR2 24-pin ATX Power Connector
JRK1 Intel RAID Key Header
JSD1, JSD2 SATA DOM Power Connectors
JSTBY1 Standby Power Header
JTPM1 Trusted Platform Module/Port 80 Connector
JVRM1 VRM SMBus Header (for programming use)
LAN1, LAN2 Dual 10G SFP+ Ports (for X11SPH-NCTPF)
LAN3, LAN4 Dual 10G BASE-T Ports (for X11SPH-NCTF)