Supermicro X11SRM-F - Quick Reference Table

13
Chapter 1: Introduction
Note: Table is continued on the next page.
Quick Reference Table
Jumper Description Default Setting
JBT1 CMOS Clear Open (Normal)
JPB1 BMC Enable/Disable Pins 1-2 (Enabled)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPL1, JPL2 LAN1/LAN2 Enable/Disable Pins 1-2 (Enabled)
JPME2 ME Manufacturing Mode Pins 1-2 (Normal)
JPUSB1 USB 0/1 Wake Up Pins 1-2 (Enabled)
JWD1 Watchdog Timer Pins 1-2 (Reset)
LED Description Status
LED6301 BMC Heartbeat LED Blinking Green: BMC Normal
LED6904 M.2 LED Blinking Green: Device Working
LED7201 Onboard Power LED Solid Green: Power On
UID-LED Unit Identier (UID) LED Solid Blue: Unit Identied
Connector Description
B2 Onboard Battery
COM1, COM2 COM Port, COM Header
FAN1 ~ FAN4, FANA, FANB CPU/System Fan Headers
IPMI_LAN Dedicated IPMI LAN Port
I-SATA0 ~ I-SATA7 Intel® PCH SATA 3.0 Ports (with RAID 0, 1, 5, 10)
I-SGPIO1, I-SGPIO2 Serial Link General Purpose I/O Connection Headers
JD1 Speaker/Power LED Indicator (Pins 1-3: Power LED, Pins 4-7: Speaker)
JF1 Front Control Panel Header
JIPMB1 4-pin BMC External I
2
C Header (for an IPMI card)
JL1 Chassis Intrusion Header
JNVME0~3 NVM Express (NVMe) PCI-Express 3.0 x4 Connectors (-VF only)
JNVI
2
C1 NVMe I
2
C Header
JOH1 Overheat LED Indicator
JPI
2
C1 Power System Management Bus (SMB) I
2
C Header
JPW1 24-pin ATX Power Connector
JPWR2 8-pin 12V CPU Power Connector
JRK1 Intel RAID Key Header
JSD1, JSD2 SATA DOM Power Connectors
JSTBY1 Standby Power Header
JTPM1 Trusted Platform Module/Port 80 Connector
JUIDB1 Unit Identier (UID) Switch