Supermicro X11SRM-F - Page 57

57
Chapter 2: Installation
ME Manufacturing Mode
Close pins 2-3 of jumper JPME2 to bypass SPI ash security and force the system to operate
in the manufacturing mode, which will allow the user to ash the system rmware from a
host server for system setting modications. Refer to the table below for jumper settings.
The default setting is Normal.
Manufacturing Mode
Jumper Settings
Jumper Setting Denition
Pins 1-2 Normal
Pins 2-3 Manufacturing Mode
MAC CODE
IPMI CODE
BAR CODE
+
1
+
1
1
1
X11SRM-F
REV:1.01
DESIGNED IN USA
1
1
1
1
1
1
1
1
1
1
Aspeed
AST2500
JNVME2
JNVME3
JNVME1
JNVME0
JBT1
JF1
JPWR2
JRK1
JTPM1
SP1
JOH1
JL1
JUIDB1
JD1
JPW1
MH10
JPI2C1
LED7201
LED6904
UID-LED
LED6301
JSD1
JSD2
I-SGPIO1
I-SGPIO2
FANB
FANA
FAN4
FAN3
FAN2
JPB1
JVRM2
JVRM1
JPG1
JPUSB1
JPME2
JPL2
JPL1
JWD1
I-SATA7 I-SATA6
I-SATA4
I-SATA5
I-SATA1
I-SATA2 I-SATA3
I-SATA0
JNVI2C1
JIPMB1
JSTBY1
B2
CLOSE 1st
OPEN 1st
M.2-PCH
ON
RST
PWR
JF1
FAIL
PS
LED
NIC
UID
1
2
NIC
LED
LED
PWR
HDD
NMI
X
FAN1 CPU
USB 10(3.0)
USB 8/9(3.0)
USB 4/5
USB 2/3
COM2
CPU SLOT4 PCI-E 3.0 x 8
CPU SLOT6 PCI-E 3.0 x 16
CPU SLOT7 PCI-E 3.0 x 8
DIMMC1 DIMMD1
CPU
LAN2
DIMMB1
LAN1
DIMMA1
IPMI_LAN
USB 6/7(3.0)
USB 0/1
VGA
COM1
Intel
i210
Intel
i210
Intel
C422
1
1. Manufacturing Mode
2. BMC Enable
2
BMC Enabled
JPB1 allows you to enable or disable the BMC (Baseboard Management Control) chip and
the onboard IPMI connection for remote system management/monitoring purpose. This jumper
is used together with the IPMI settings in the BIOS. After the BMC is disabled, IPMI health
monitoring and remote management functions are no longer supported.
Note: Please always keep BMC enabled to make sure the platform operates reliably
with the health monitor.
BMC Enable
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled