Supermicro X11SRM-F - Page 77

Chapter 4: BIOS
77
Memory Conguration
Enforce POR
Select POR (Plan of Record) to enforce POR restrictions on DDR4 frequency and volt-
age programming. The options are Auto, POR and Disable.
Memory Frequency
Use this feature to set the maximum memory frequency for onboard memory modules.
The options are Auto, 1000, 1200, 1333, 1400, 1600, 1800, 1866, 2000, 2133, 2200,
2400, 2600, and 2666.
Custom Refresh Enable
Use this feature to enable a custom memory controller refresh rate. The options are
Disable and Enable.
MC BGF Threshold
Use the HA to MC BGF threshold feature to schedule MC requests in bypass condition.
The default value is 0.
DLL Reset Test
Use this feature to set the number of loops to execute the Dynamic Link Library (DLL)
reset test. The test will execute the Rank Margin Test (RMT) for the provided number of
loops without DLL resets. Then it will execute RMT for the same number of loops with
DLL resets. The default value is 0.
Memory Topology
This item displays the information of onboard memory modules as detected by the
BIOS.
Memory RAS Conguration
Static Virtual Lockstep Mode
Select Enable to run the system's memory channels in lockstep mode to minimize
memory access latency. The options are Disable and Enable.
Mirror Mode
This feature allows memory to be mirrored between two channels, providing 100%
redundancy and consequently reducing the memory capacity by half. The options are
Disable, Mirror Mode 1LM, and Mirror Mode 2LM.