11
Chapter 1: Introduction
Note: Table is continued on the next page.
Quick Reference Table
Jumper Description Default Setting
JBT1 CMOS Clear Open (Normal)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPME1 ME Recovery Pins 1-2 (Normal)
JPME2 ME Manufacturing Mode Pins 1-2 (Normal)
JPO1 Power Fail Override Pins 2-3 (Disabled)
JWD1 Watch Dog Pins 1-2 (Reset)
LED Description Status
LED5 Rear UID LED Blue: On; Unit Identied
LED6 BMC Heartbeat LED Green: Blinking; BMC Normal
Connector Description
BT1 Onboard Battery
I-SATA0 ~ I-SATA6 SATA 3.0 Connections
J21 CPU Micro-LP PCI-E 3.0 x8 Slot
JKVM1/VGA
KVM/VGA (Monitor) (UART) Connector for Remote Console Redirection or Remote Network
Interface
JSD1 SATA Disk On Module (DOM) Power Connector
JTPM1 Trusted Platform Module (TPM)/Port 80 Connector
JUIDB1 UID (Unit Identication) Switch
SW2 Power Switch/LED Indicator
USB0/1 Back panel USB 2.0 ports via KVM
USB2 USB 3.0 Type-A Header
To Next Page
Loading...
