20
X11SSE-F User Manual
2.2 Motherboard Installation
All motherboards have standard mounting holes to t different types of chassis. Make sure
that the locations of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are
highly recommended because they ground the motherboard to the chassis. Make sure that
the metal standoffs click in or are screwed in tightly.
Location of Mounting Holes
Note: 1) To avoid damaging the motherboard and its components, please do not use
a force greater than 8 lb/inch on each mounting screw during motherboard installation.
2) Some components are very close to the mounting holes. Please take precautionary
measures to avoid damaging these components when installing the motherboard to
the chassis.
Philips
Screwdriver
(1)
Standoffs (10)
Only if Needed
Philips Screws
(10)
Tools Needed
BMC
Intel PCH
CPU
USB2 (3.0)
I-SATA6
JSD1
SW2
LED5
JUIDB1
LED6
MAC CODE
BAR CODE
BIOS
LICENSE
JPG1
JKVM1/VGA
USB0/1
BT1
JWD1
JPME2
JPME1
JTPM1
JBT1
CPU MICRO-LP PCI-E 3.0 X8
JPO1
J21
MICRO-LP
DIMMB2
DIMMB1
DIMMA2
DIMMA1
I-SATA0
X11SSE-F
Rev. 1.01
To Next Page
Loading...
