Supermicro X12DAi-N6 - Page 148

Super X12DAi-N6 User's Manual

When SEL is Full
This feature allows the user to decide what the BIOS should do when the system event log
is full. Select Erase Immediately to erase all events in the log when the system event log is
full. The options are Do Nothing and Erase Immediately.
Note: After making changes on a setting, be sure to reboot the system for the changes
󰀨
BMC Network Conguration
Update BMC LAN Conguration
Select Yes for the BIOS to implement all IP/MAC address changes upon next system boot.
The options are No and Yes.
Congure IPV4 Support

BMC LAN Selection
This item displays the BMC LAN setting. The default setting is Failover.
BMC Network Link Status
This item displays the BMC Network Link status. The default setting is Dedicated LAN.
Conguration Address Source
This feature allows the user to select the source of the IP address for this computer. If Static
is selected, you will need to know the IP address of this computer and enter it to the system


IP address for this computer. The options are DHCP and Static.
*If the item above is set to Static, the following items will become available for
conguration:
Station IP Address
This item displays the Station IP address for this computer. This should be in decimal and in

Subnet Mask
This item displays the sub-network that this computer belongs to. The value of each three-
digit number separated by dots should not exceed 255.
Station MAC Address
This item displays the Station MAC address for this computer. Mac addresses are 6 two-digit
hexadecimal numbers.