Supermicro X12DAi-N6 - Page 30

30
Super X12DAi-N6 User's Manual
Lever
3. Locate the lever on the CPU socket and press the lever down as shown below.Using
4. Using Pin 1 as a guide, carefully align the CPU keys (A and B) on the processor against
the CPU keys on the carrier (a and b) as shown in the drawing below.
5. Once they are properly aligned, carefully place one end of the processor into the latch
marked 1 on the carrier, and place the other end of processor into the latch marked 2.
1
2
A
B
Latch
Latch
a
CPU Key (on the
processor)
CPU Key (on the
carrier)
CPU Key (on the
processor)
CPU Key (on
the carrier)
b