106
Super X13DEG-OA User's Manual
when supported by the motherboard.)
Optimized Power Mode (Available when "Power Technology" is set to Custom)
Set this feature to Enable to reduce overall power consumption. The options are Disable
and Enable. When this feature is set to Enable, the features below will be automatically
set by the BIOS:
• "Power Performance Tuning" - BIOS controls EPB
• "ENERGY_PERF_BIAS_CFG Mode" - Balanced Performance
• "Enhanced Halt State (C1E)" - Enable
CPU P State Control
AVX P1 (Available when "SpeedStep (P-States)" is set to Enable)
Use this feature to set the appropriate TDP level for the system. The Intel Advanced
Vector Extensions (Intel AVX) P1 feature allows you to set the base P1 ratio for Streaming
SIMD Extensions (SSE) and AVX workloads. Each P1 ratio has the corresponding AVX
Impressed Current Cathodic Protection (ICCP) pre-grant license level, which refers to
AVX feature to operate normally, which will provide a set of instructions to allow Single-
Instruction Multiple-Data (SIMD) operations to be performed in Intel processors by adding
MMX and SSE support. The options are Nominal, Level 1, and Level 2.
SpeedStep (P-States)
heat dissipation. Please refer to Intel’s website for detailed information. The options are
Disable and Enable.
EIST PSD Function (Available when "SpeedStep (P-States)" is set to Enable)
This feature reduces the latency that occurs when one P-state changes to another, thus
allowing the transitions to occur more frequently. This will allow for more demand-based
P-state switching to occur based on the real-time energy needs of applications so that
are HW_ALL and SW_ALL.
Turbo Mode (Available when "SpeedStep (P-States)" is set to Enable)
increasing CPU clock frequency. This feature is available when it is supported by the
processors used in the system. The options are Disable and Enable.
To Next Page
Loading...
