Supermicro X13DEG-OA - Serial Port and Console Redirection

126
Super X13DEG-OA User's Manual
Spin Up Device

       󰀨   
from spinning up at the same time, causing a power surge. The options are Disabled and
Enabled.
SATA Device Type
      
should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
Super IO Conguration (Available when your system supports
this feature)
The following information is displayed.
• Super IO Chip
Serial Port 1 Conguration
Serial Port 1
Select Enabled to enable serial port 1. The options are Disabled and Enabled.
Device Settings (Available when "Serial Port 1" above is set to Enabled)
This feature displays the base I/O port address and the Interrupt Request address of serial
port 1.
Change Settings (Available when "Serial Port 1" above is set to Enabled)

port 1. Select Auto for the BIOS to automatically assign the base I/O and IRQ address to
serial port 1. The options are Auto, (IO=3F8h; IRQ=4;), (IO=3F8h; IRQ=3, 4, 5, 6, 7, 9,
10, 11, 12;), (IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;), (IO=3E8h; IRQ=3, 4, 5, 6, 7, 9,
10, 11, 12;) and (IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12;).
Serial Port 2 Conguration
Note:            
system support.
Serial Port 2
Select Enabled to enable serial port 2 (or SOL). The options are Disabled and Enabled.