Supero SC813 Series User Manual

Adding a Floppy Drive
1-1
SC813M Chassis
Adding a Floppy Drive
1-1 Overview
The SC813M series of chassis includes the SC813MS-420C, the SC813MT-420C,
the SC813MS-300C and the SC813MT-300C. These chassis come equipped with
a front side USB/COM port tray as part of the standard configuration. Supermicro
has designed the SC813M series so that the USB/COM port tray can be replaced
with a slim floppy drive. This addendum describes the process involved to remove
the front side USB/COM port tray and replace it with a slim floppy drive.
Floppy Kit
Before installing a slim floppy drive, you must obtain a floppy kit from your
Supermicro representative and a slim floppy drive (not included in the kit). The
items included in the floppy kit are listed below and shown in Figure 1.
The floppy kit contains:
 One (1) floppy drive adapter
 Two (2) floppy drive rails
 One (1) floppy drive ribbon cable (to motherboard)
 One (1) small ribbon cable (to adapter)
 One (1) power cable
 Five (5) screws (one large, four small)

Supero SC813 Series Specifications

General

Brand	Supero
Model	SC813 Series
Category	Chassis
Language	English