SuperPro DDAC-1 - Installation; Button Functions

Page 2 DDAC-1
Installation
Secure the unit to a wall.
Determine the best location for the remote probe. Place the
probe in an area with good air movement preferably at plant
height. Avoid placing the probe in direct sunlight or under
direct HID Lighting.
NOTE: Do not place the sensor probe where it will
come in to contact with water. NOT WATER PROOF!
The remote probe has a quick disconnect to easily remove or
connect the probe. Secure the quick disconnect to the unit by
securing the QD screw to the unit.
Plug the power cable into a standard NEMA 5-15 wall outlet. A
120 volt power supply is required.
Turn the power on and allow it to warm up. This takes about 5
minutes. During the warm up period, the display will read CO2
heat.
Note: Now is the time to customize your settings
prior to connecting any equipment.
Ensure that all of the devices being connected to the controller
have the proper voltage and will not exceed the maximum
amperage rating of this unit.
NOTE: If using a large amperage device such as an
Air Conditioner or De-humidifier is used, a power
expansion module may be required.
Page 3 DDAC-1
Button Functions
The fifteen (15) buttons located on the front face control all
the functions. Pressing each button will display a function
and/or current setting(s) in the green LED window. Some
buttons perform more than one function.
Several small green LED lights or status indicators located
on the front panel will light up to show selected function when
certain buttons are pressed.
Up
- Press button to increase setting
Down
- Press button to decrease setting
Enter/Reset
- Press button, hold for 3 seconds to enter new
setting and to reset the Min/Max range.
Temperature buttons
Temp day setting
- Press button to set day cooling and
heating Settings.
Temp night setting
- Press button to set night cooling and
heating Settings.
Temp dead-band - Press button to set the cooling and
heating dead-band setting.
Humidity buttons
Humid setting
- Press button to set Day and Night humidity
Settings.
Humid mode
- Press button to select the humidification (rH
Incr) or de-humidification (rH decr) mode.
Humid dead-band
- Press button to set the humidity dead -
band setting.