V
ENGLISHFRANÇAIS
FCC INFORMATION (For US customers)
1. COMPLIANCE INFORMATION
Product Name: Integrated Amplifier
Model Number: a210
This product complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this product
may not cause harmful interference, and (2) this product must accept any interference received, including interference that
may cause undesired operation.
SUPERSCOPE TECHNOLOGIES, INC.
1508 BATAVIA AVENUE
GENEVA, IL 60134 USA
2. IMPORTANT NOTICE: DO NOT MODIFY THIS PRODUCT
This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modification
not expressly approved by SUPERSCOPE may void your authority, granted by the FCC, to use the product.
3. NOTE
This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This product generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can
be determined by turning the product OFF and ON, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the product into an outlet on a circuit different from that to which the receiver is connected.
• Consult the local retailer authorized to distribute this type of product or an experienced radio/TV technician for help.
For Canadian customers:
This Class B digital apparatus complies with Canadian ICES-003.
CAUTIONS ON INSTALLATION / PRÉCAUTIONS D’INSTALLATION
Wall
Paroi
*
**
*
* For proper heat dispersal, do not install this unit in
a confined space, such as a bookcase or similar
enclosure.
• Leave sufficient clearance (at least 4 inches) from the wall,
(at least 2 inches) from top surface of the unit.
• Do not place any other equipment on this unit.
* Pour permettre la dissipation de chaleur requise,
n’installez pas cette unité dans un espace confiné tel
qu’une bibliothèque ou un endroit similaire.
• Veillez à laisser un espace suffisant (au moins 10 cm)
avec le mur, (au moins 5 cm) avec la surface supérieure de
l’appareil.
• Ne placez aucun matériel sur cet appareil.
To Next Page
Loading...
