— 60
© 2016 Skier’s Choice, Inc.
System Information
On the Main Menu screen, touch [System Info] to access the System Information screen. This
information-only screen provides the following:
• Application version and part number
• Operating system version and part number
• Bootloader version and part number
• Software version
• PDM Software Version Address(es)
Ballast/Smartplate Settings
On the Main Menu screen, touch [Ballast/Smartplate Settings] to access the
Ballast/Smartplate Settings screen. This screen provides default fill times for ballasts and
default settings for the Smartplate.
To access the edit points of the Ballast and Smartplate settings, with the cell highlighted, touch
the [Up] or [Down] arrows to change the setting.
NOTE: The [Crossover Point] defaults to 50 percent of your set speed.
This is the point at which the Smartplate will be automatically driven to the
active profile set point. If no set point is active, the Smartplate will be
driven to the [Smartplate Up] setting (default 50 percent).
The [Smartplate Down] setting (default 100 percent) is the position that
the Smartplate is driven to below the crossover setting.
Having the Smartplate deployed to 100 percent when the boat is at rest
and then automatically retracting to the Smartplate set point at the
crossover is what helps the boat keep the bow down and on plane during
acceleration.
To Next Page
Loading...
