Step 2. Install the Inside Patch Antenna
Identify a location for the inside antenna on or near your front dashboard that is
Within 2-3 feet of the typical cell phone location
At least 8 inches (20cm) from cellular devices and
At least 4 inches (10cm) from metal
Next, peel Velcro backing and apply to a clean dry surface in your chosen location.
Or try this – Use the free vent clip provided with your product as a mounting surface then simply clip to an air vent.
Step 3.Place Booster and Connect Cables
Select a well-ventilated location for the booster that is away from excessive heat, direct sunlight, and moisture. We often suggest
installing beneath a seat or within the front console. Connect the cable from the outside antenna to the connection marked
OUTSIDE and connect the cable from inside patch antenna to the connection marked INSIDE. Tighten the connections and wrap up
any loose cable.
Step 4. Connect Power
Connect the power cord connector to the signal booster and insert the other end into your cigarette lighter adapter1. The Power
LED illuminates to show that the signal booster is ready for use. The Alert LEDs flash 5 times to show the frequency band is
operational. Place a call in a location you have previously experienced poor signal and confirm that your phone is receiving a
boosted signal. Note: When your car is off, turn the power switch to OFF to keep the booster from continuing to draw power from
your vehicle.
To Next Page
Loading...
