WEP Key:
Key 1 - Key 4: These four fields can be used to manually enter the encryption keys. This may be necessary if you wish
this node to match keys in a different vendor's product.
WEP Key length: The 64 or 128-bits Wired Equivalent Privacy Algorithm. You can decide the network key to be
encoded by ASCII characters or hexadecimal digitals. A key of 10 hexadecimal characters (0-9, A-F) is required if a
64-bit Key Length was selected. A key of 26 hexadecimal characters (0-9, A-F) is required if a 128-bit Key Length
was selected.
4.1.2 Link Status
You can see the below status:Status, Current Channel, Current TX Rate, throughput(Kbit/sec), Link Quality, Signal
Strength.
To Next Page
Loading...
General