DescriptionValueSetting
Zone 1: upper and lower limit in percent of
maximum heart rate
% - %z1
Zone 2: upper limit%z2
Zone 3: upper limit%z3
Zone tone: on or offon / offtone
To change HR ZONES settings:
1. Enter the menu (SET) and scroll with [Lap +] until you reach HR ZONES.
2. Enter the setting with [Mode] and set the value using [Lap +] and [Light -].
3. Accept the value and move to the next setting by pressing [Mode].
4. Repeat steps 2 and 3 as needed.
5. Press [Start Stop] to exit.
TIP: If your heart rate varies significantly during training, for example, when running
in hilly terrain, following your real-time average heart rate is better guidance than following
zone limits.
3.7 Using intervals and warm-up
Your Suunto heart rate monitor supports interval training, training with alternating
periods of high exertion and recovery. Use INT1, INT2 to define different interval durations.
22
To Next Page
