using the pressure cleaner, release the trigger and switch the unit to the OFF position. The unit
should be turned completely OFF while not in use or while unattended.
Bleeding the Gun
It is very important to bleed the gun before using the pressure cleaner. Refer to the “Assembly
Instructions” to assemble the pressure cleaner. To bleed the gun, simply connect the garden
hose to the pressure cleaner and squeeze the trigger BEFORE turning the electrical supply on.
This allows any air trapped inside the pressure cleaner and gun to be removed before using the
unit. Continue holding trigger for approximately one minute to allow any excess air out of the unit.
Water will flow through the gun at low pressure during this procedure. For more bleeding tips, see
the section titled “Operating Instructions.”
Gun Safety Lock
This pressure cleaner is equipped with a gun trigger safety lock. When not using the pressure
cleaner, use the safety lock to keep from accidentally engaging the high pressure spray.
To Next Page
Loading...