EasyManua.ls Logo

Suyncll AMD005284 - Cleaning and Maintenance; Unit Maintenance; Surface Cleaning Techniques

Default Icon
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
After disconnecting the water supply, and before disconnecting the high-pressure hose,
turn the pressure cleaner on for 2-3 seconds, until any remaining water in the pump exits.
TURN UNIT OFF IMMEDIATELY.
CONTINUED USE OF THE PRESSURE CLEANER WITHOUT
WATER SUPPLY ATTACHED WILL CAUSE
SEVERE DAMAGE TO THE UNIT!
Always store the pressure cleaner, parts, and accessories in an area with a temperature
above 0° C (32° F).
WARNING: FAILURE TO COMPLY WITH THESE
STORAGE INSTRUCTIONS WILL RESULT IN
DAMAGE TO THE PUMP ASSEMBLY
.
Maintenance
This pressure cleaner is supplied with a closed lubrication system, so no addition of oil is
needed.
Check all hoses and accessories for damage prior to use.
Check the inlet filter periodically for deposits. Clean this filter regularly for maximum
performance.
CLEANING TIPS
WARNING: ALWAYS TEST THE SPRAY IN AN AREA FREE AND CLEAR OF PEOPLE AND
OBJECTS BEFORE YOU SPRAYAT THE INTENDED CLEANING SURFACE.
Wood and Vinyl Decks
Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent reservoir
and apply to the area being cleaned at low pressure. For optimal results, reduce your work area
to smaller sections and clean each section one at a time. Allow the detergent to rest on the
surface for a few minutes
and then rinse at high pressure. DO NOT LET THE CLEANSER DRY.
Always clean from left to right and top to bottom for best results. Rinse at high pressure using
the fan spray keeping the tip of the spray nozzle at least 6-9 inches from the cleaning surface.
Maintain a further distance from the cleaning area when using a direct spray. Caution: For softer
woods, increase the distance from the cleaning area.
Cement Patios, Stone, and Brick
Rinse cleaning and surrounding area with fresh water. If using detergent, fill the detergent
reservoir and apply to the area being cleaned at low pressure. Rinse at high pressure using the
fan spray in a sweeping motion keeping the tip of the spray nozzle at least 3-6 inches from the
cleaning surface. Maintain a further distance from the cleaning area when using a direct spray.
Cars, Boats, and Motorcycles