Suyncll AMD005284 - CLEAN-UP AND STORAGE; Shutting Down the Pressure Cleaner; Winterizing and Long-Term Storage

15
WARNING: NEVER USE PRODUCTS WITH BLEACH OR CHLORINE
OR ANY OTHER CORROSIVE MATERIALS, INCLUDING LIQUIDS CONTAINING SOLVENTS
(I.E. GAS, OILS ETC), TRI-SODIUM PHOSPHATE PRODUCTS, AMMONIA, OR ACID-BASED
CLEANERS. THESE CHEMICALS WILL HARM THE UNIT AND CAUSE DAMAGE TO THE
SURFACE BEING CLEANED. ALWAYS READ THE LABEL.
- E. GAS, OILS ETC), TRI-SODIUM PHOSPHATE PRODUCTS, AMMONIA, OR ACID-
BASED CLEANERS. THESE CHEMICALS WILL HARM THE UNIT AND CAUSE
DAMAGE TO THE SURFACE BEING CLEANED. ALWAYS READ THE LABEL.
CLEAN-UP AND STORAGE
Shutting Down the Pressure Cleaner
WHEN FINISHED USING THE PRESSURE CLEANER,
FOLLOW THESE STEPS TO SHUT
DOWN THE UNIT:
 Turn the pressure cleaner to the OFF position.
 Turn off the water supply.
 Before disconnecting high-pressure hose connection, point the gun in a safe direction
and discharge the high-pressure water.
 Disconnect high-pressure hose from the pressure cleaner and gun.
 Disconnect garden hose from the pressure cleaner.
 Remove quick coupler fitting from garden hose and attach to the nipple portion of the
fitting installed on the pressure cleaner for storage.
 Remove excess water from the pump by tipping the unit on both sides to drain any
remaining water from inlet and outlet fittings.
 Remove Water Intake Filter and flush with water to remove dirt or debris. Return
filter once cleaned.
 Drain detergent reservoir and flush with running water.
 Wipe away any remaining water on all parts and fittings.
 Engage the gun safety lock.
 Store the pressure cleaner, parts, and accessories in an area with a temperature
above 0°C (32° F).
Winterizing and Long-Term Storage
FOLLOW ALL OF THE ABOVE SHUT-DOWN PROCEDURES,
ADDING THE FOLLOWING STEPS….