8-5 POWER TRIM AND TILT
Pull the tilt rod / piston assembly 1 out of the cylinder body.
Remove the free piston from the cylinder body 2.
Remove the PTT motor.
Note the position of drive joint 3 and O-ring 4, before remov-
ing them.
(see page 8-10)
Unscrew the fill plug and drain PTT oil into suitable container.
Remove the manual release valve snap ring 5, then unscrew
the manual release valve 6.
Remove the seal washer 7.
Remove the main check valve 8 and spool valve 9.
To Next Page
