LOWER UNIT 9-20
WATER PUMP ( Impeller & Case )
Place the under panel gasket 1 and under panel 2 into posi-
tion.
Insert the key 3 in the driveshaft and slide the impeller 4 onto
driveshaft, ensuring that key and keyway are aligned.
Install the pump case 5 while rotating driveshaft clockwise to
flex the impeller vanes in the correct direction.
Securely tighten the four (4) pump case nuts to the specified
torque.
Pump case nut : 8 N
.
m (0.8 kg-m, 5.8 lb.-ft.)
PROPELLER INSTALLATION
Install propeller stopper 1 onto propeller shaft, then slide on
the propeller 2.
Fit spacer 3, washer 4 and nut 5, then tighten nut to speci-
fied torque.
Push cotter pin 6 through nut and shaft, then bend to secure.
99000-25160 : Water Resistant Grease
Propeller nut : 55 N
.
m (5.5 kg-m, 40.0 lb.-ft.)
l
1
2
3
4
5
6
@
@
To Next Page
