INSTALLATION
Installation
is
reverse order of removal with special attention
to
the following steps .
• Install starter motor and stator base, then tighten stator base
mounting
bolts securely.
~
Stator base mounting bolt:
8 mm
23
N·m (2.3 kg-m, 16.S Ib-ft)
6
mm
10 N·m (1.0 kg-m, 7.0 Ib-ft)
DISASSEMBLY
When overhauling starting motor,
it
is
recommended that com-
ponent parts be cleaned thoroughly.
However, the yoke assembly, armature coil, over-running clutch
assembly, magnetic switch assembly, and rubber or plastic
parts should not be washed
in
a degreasing tank or with a
grease
dissolving solvent. These parts should
be
cleaned with
compressed air or wiped with
clean cloth.
NOTE:
Before disassembling starting motor, be sure
to
put
match
mArkr;
at
two locations
(A
and B) as shown
in
figure
at
right
to
avoid
any
possible component alignment mistakes.
1.
Remove nut
CD
from magnetic switch, then disconnect the
connecting wire
12).
2.
Remove two bolts @ securing magnetic switch.
3.
Remove the magnetic switch @ and rubber packing
':ID.
DF40/S0
"KS"
(,OS)
MODEL
23
To Next Page
