19
NOTE:
• If a passcode is not entered during the 10
sounds, the process will start over again after
briefly turning the switch.
• If the main switch is not turned to select a
passcode number after repeating the pass-
code input operation three (3) times, the input
operation is cancelled.
In this case, the buzzer emits short beeps for
five (5) seconds to notify that the input opera-
tion has been cancelled.
• If the passcode input operation has been per-
formed multiple times, the last passcode
entered will become effective.
• To interrupt passcode input, install the lock
plate on the emergency stop switch.
NOTE:
When performing the passcode input operation
again after the operation has been cancelled
due to passcode input failure or after having
interrupted the operation;
1) Install the emergency switch lock plate.
2) Turn the main switch to the “ON & OFF”
position and then release it to the “PUSH
START/STOP” position.
3) Perform the procedure described above
from Step 5.
(5)After the buzzer has sounded once, the key-
fob LED will blink the entered passcode.
ON & OFF ON & OFF
Hold it for five (5) seconds.
PUSH
START
STOP
PUSH
START
STOP
Example: In the case of passcode 1234
Number of key-fob blinks
LED
(6)Install the lock plate on the emergency stop
switch.
(7)Turn the main switch to the “ON & OFF”
position and then release it to the “PUSH
START/STOP” position to turn the Keyless
Start System OFF.
After that, do not perform any operation for
at least 30 seconds, while the system per-
forms passcode update.
PASSCODE CONFIRMATION
1. Confirm that the engine is stopped.
2. Make sure the emergency switch lock plate
is in place.
3. Confirm the key-fob is within the communi-
cation range of the Keyless Start System.
4. Confirm the key-fob is in ON mode. (Refer to
“Switching the communication mode of the
key-fob” section.)
5. Turn the main switch to the “ON & OFF”
position and then release it. The main switch
automatically returns to the “PUSH START/
STOP” position.
The buzzer on the engine control side emits
one (1) long sound while the buzzer on the
keyless control unit side emits two (2) short
sounds simultaneously.
ON & OFF ON & OFF
PUSH
START
STOP
PUSH
START
STOP
To Next Page
Loading...
