EasyManua.ls Logo

Suzuki DF100B - Page 51

Suzuki DF100B
77 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
51
OPERATING THE TROLL MODE
(Optional Item)
Trolling speed can be controled to install the
optional Troll Mode switch.
Please contact your authorized Suzuki Marine
Dealer for more information.
NOTE:
To monitor engine speed correctly during the
troll mode operation, Suzuki recommends the
use of the Suzuki 2-scale Monitor Tachometer.
System Outline
The “Troll Mode System” is activated by press-
ing the troll mode switch, when the motor is run-
ning at in-gear idle speed. By using this system,
you can set and maintain a desired engine
speed with the control switch in a range from
in-gear idle speed (approx. 700 r/min) to 1200
r/min.
How to use the Troll Mode
Setting the troll mode:
1. Shift into forward or reverse gear and make
sure that the throttle is fully closed (in-gear
idle speed).
2. Press the “UP” or “DN” position of the troll
mode switch, until you hear one beep.
The REV/TRL (or REV) lamp on the monitor
gauge will flash indicating that the motor has
been set to the troll mode. The REV/TRL (or
REV) lamp will continue to flash while the
motor is in the troll mode.
Usual scale
Trolling mode scale
Troll mode switch
NOTE:
The troll mode system will not operate if the
switch is depressed when the remote control
lever is in the neutral position.
Adjusting trolling speed:
When pressing the “UP” switch, one short
beep sounds and the engine speed
increases by 50 r/min.
When pressing the “DN” switch, one short
beep sounds and the engine speed
decreases by 50 r/min.
NOTE:
When pressing the “DN” switch at the lower
limit of trolling speed, the engine speed will
not change and three long beeps will sound.
When pressing the “UP” switch at the upper
limit of trolling speed, the engine speed will
not change and three long beeps will sound.
Shift operation and throttle control remain
operational, even in troll mode.
Cancelling the troll mode:
The troll mode can be cancelled by shifting the
remote control lever to the neutral position, or
by increasing the engine speed to 3000 r/min or
more. In both cases, two short beeps sound
when cancelling the troll mode.

Related product manuals