Suzuki DF40A - THROTTLE TENSION ADJUSTMENT; SETTING TILT UPPER LIMIT POSITION

19
THROTTLE TENSION ADJUSTMENT
TILLER HANDLE MODEL
The tension of the throttle control grip can be
adjusted according to your preference. To
increase the tension, turn the throttle tension
adjuster A clockwise. To decrease the tension,
turn the adjuster counterclockwise.
REMOTE CONTROL MODEL
The tension of the remote control handle can be
adjusted according to your preference. To
increase the tension, turn the throttle tension
adjuster A clockwise. To decrease the tension,
turn the adjuster counterclockwise.
IDLE SPEED ADJUSTMENT
The idle speed has been factory adjusted
between 750 – 850 r/min in neutral.
NOTE:
If idle speed cannot be set within the specified
range, contact your authorized Suzuki Marine
Dealer.
Increase
Decrease
SETTING OF TILT UPPER LIMIT POSITION
DF40A (ST), DF50AV (T/TH),
DF60A (T/TH), DF60AV (T/TH) MODEL
If the outboard motor contacts the motor well of
the boat during full tilt up operation, the upper
limit setting should be reset.
Perform this set-up after the current position
setting has been canceled, as explained in the
following procedure.
CANCELING THE TILT UPPER POSITION
LIMIT SETTING
1. Turn the ignition key to the “ON” position.
2. Pull out the emergency stop switch lock
plate.
3. Shift the motor into “NEUTRAL”.
“NEUTRAL”
“NEUTRAL”