7-23
To adjust the drive chain, follow
the procedure below:
1. Place the motorcycle on the
side stand.
2. Loosen the axle nut 1.
3. Loosen the lock nut 2 (right
and left).
4. Turn the right and left adjuster
bolts 3 until the chain has 20
– 30 mm (0.8 – 1.2 in) of slack
halfway between the engine
sprocket and rear sprocket.
5. At the same time that the
chain is being adjusted, the
rear sprocket must be kept in
perfect alignment with the front
sprocket. To assist you in per-
forming this procedure, there
are reference marks 4 on the
swing arm and each chain
adjuster which are to be
aligned with each other and to
be used as a reference from
one side to the other.
6. Tighten the lock nut 2 (right
and left).
7. Tighten the axle nut 1
securely.
8. Recheck the chain slack after
tightening and readjust if nec-
essary.
Rear axle nut tightening torque:
100 N·m (10.0 kgf-m, 72.5 lbf-ft)
WARNING
A hot muffler can burn you. The
muffler will be hot enough to
burn you for some time after
stopping the engine.
Wait until the muffler cools to
avoid burns.
To Next Page
Loading...
