Suzuki DR600S - Page 127

6-3 CHASSIS
SPOKE NIPPLE
Check
to
be
sure
that
all
nipples
are
tight,
and
retighten
them
as
necessary
using
special
tool.
4—5N-m
Tightening
torque
|
(ee
—0.5
<0)
3.0
—
3.5
Ib-ft
DUST
SEAL
OF
SPEEDOMETER
GEARBOX
Inspect
the
lip
of
dust
seal
for
damage.
If
any
damage
is
found,
replace
it
with
a
new
one.
DISASSEMBLY
e@ Drive out the wheel hub bearings by using the
special tool in the following procedures.
@ Insert the adapter into the wheel hub bearing.
e After inserting the wedge bar from the oppo-
site side, lock the wedge bar in the slit of the
adapter.
@ Drive out the wheel hub bearing by knocking
the wedge bar.
CAUTION:
The removed bearing should be replaced.