Suzuki DR600S - Page 133

6-9 CHASSIS
—————— eee
CALIPER REASSEMBLY AND
REMOUNTING
Reassemble
and
remount
the
caliper
in
the
reverse
order
of
disassembly
and
removal.
Pay
attention
to
the following points:
[ CAUTION:
* Wash the caliper components with fresh
| brake fluid before reassembly.
| * Never use cleaning solvent or gasoline to
wash them.
* Apply brake fluid to the caliper bore and
piston to be inserted into the bore.
e Apply SUZUKI silicone grease to the caliper
axles.
99000-25100 SUZUKI silicone grease
—
| WARNING:
Bleed the air after reassembling the caliper.
(See page 2-14)
MASTER CYLINDER REMOVAL AND
DISASSEMBLY
e After removing the knuckle guard, place a cloth
underneath the union bolt on the master cylinder
to catch spilled drops of brake fluid. Unscrew
the union bolt and disconnect the brake hose/
master cylinder joint.
CAUTION:
Completely wipe off any brake fluid adhering
to any part of motorcycle. The fluid reacts
chemically with paint, plastics, rubber mate-
rials, etc.
Disconnect the brake light switch lead wire.
Remove the two clamp bolts and take off the
master cylinder assembly.