Suzuki DR600S - Page 75

341 SERVICING ENGINE
DRIVESHAFT
DISASSEMBLY
e After removing the Low driven gear and Top
driven gear, remove the 3rd driven gear circlip
@® from the groove and slide circlip toward the
4th driven gear @).
09900-06104 Snap ring pliers
Then, remove the 3rd driven gear by removing
the lock washers, @) and @.
e
After
removing
the
4th
driven
gear,
remove
the
2nd
driven
gear
by
removing
the
circlip.
09900-06107 Snap ring pliers
COUNTERSHAFT
AND
DRIVESHAFT
REASSEMBLY
Assemble
the
countershaft
and
driveshaft,
in
the
reverse
order
of
disassembly.
Pay
attention
to
following
points:
NOTE:
a
Always
use
new
circlips.
[ NOTE:
Before
installing
the
gears,
coat
lightly
moly
Paste
or
engine
oil
to
the
driveshaft
and
countershaft.
CAUTION:
*
*
+
Never
reuse
a
circlip.
After
a
circlip
has
been
removed
from
a
shaft,
it
should
be
discarded
and
a
new
circlip
must
be
instal-
led.
When installing a new circlip, care must be
taken not to expand the end gap larger
than required to slip the circlip over the
shaft.
After installing a circlip, always insure that
it is completely seated in its groove and
securely fitted.
— Thrust
@
When
installing
a
new
Circlip,
pay
attention
to
the
direction
of
the
circlip.
Fit
it
to
the
side
where
the
thrust
is
as
shown
in
figure.
Sharp edge