Suzuki DR600S - Page 90

e After installing the primary driven gear assembly
and related clutch parts onto the countershaft,
tighten the clutch sleeve hub nut to the specified
torque by using the special tool and torque
wrench.
09920-53722 Clutch sleeve hub holder
40 —60 N-m
Tightening torque ( 4.0 — 6.0 kg-m )
29.0 — 43.0 Ib-ft
e After tightening the clutch sleeve hub nut, be
sure to lock the nut by firmly bending the
tongue of the lock washer.
e Tighten the clutch spring mounting bolts diago-
nally to the specified torque by using the special
tool and torque wrench.
11—13N-m
Tightening torque ( 1.1 — 1.3 kg-m )
8.0 — 9.5 lb-ft
e Fit the two dowel pins (@) to the crankcase and
attach a new gasket.
CAUTION:
Use a new gasket to prevent oil leakage.
SERVICING ENGINE 3-56