Suzuki DR600S - Page 92

e Fit the O-ring to the O-ring groove as shown in
Fig.
CAUTION: (ee py
Use a new O-ring to prevent oil leakage.
NOTE:
Coat the O-ring of sump filter cap with grease.
e When installing the oil sump filter cap, be sure
to face the arrow mark on the cap to the front.
OIL RING
Install the spacer () into the oil ring groove first.
Then, install both side rails), one on each side
of the spacer. The spacer and side rails do not have
a specific top or bottom when they are new. When
reassembling used parts, install them in their
original place and direction.
TOP RING AND 2ND RING
The top ring and 2nd ring differ in the letter of the
top mark. The 2nd ring letter size is larger than the
top one. Be sure to bring the marked side to top
when fitting them to the piston,
SERVICING
ENGINE
3-58
Letter size
0.87 mm
TOP RING