Suzuki DR600S - Page 94

CYLINDER
Before
mounting
the
cylinder,
oil
the
big
end
and
small
end
of
the
conrod
and
also
the
sliding
surface
of the piston.
e Fit the dowel pins to the crankcase and
attach new gasket.
CAUTION:
To prevent oil leakage, do not use the old
gasket again, always use new one.
e Uniformly apply SUZUKI BOND NO. 1207B to
the cylinder base gasket.
99000-31140 | Suzuki bond No, 1207B
Hold each piston ring with properly position,
and insert the piston into the cylinder.
NOTE:
When mounting the cylinder, keep the cam-
shaft drive chain (2) taut. The camshaft
drive chain must not be caught between cam
drive chain sprocket and crankcase when
crankshaft is rotated.
NOTE:
There is a holder for the bottom end of the
cam chain guide cast in the crankcase. Be sure
that the cam chain guide is inserted properly.
CYLINDER HEAD
e Fit the dowel pins (1) to the cylinder and
attach a new gasket. 1!) 4: — 14 AQ)!
e
Uniformly
apply
SUZUKI
BOND
NO.
12078
to
the
cylinder
head
gasket.
iia
99000-31140
[suzuki
bond
No.
1207B
|
CAUTION:
f
Use a new cylinder head gasket to prevent oil
leakage. Do not use the old gasket.
SERVICING
ENGINE
3-60
GaskeC 1124) -14 Ao2
vt LOU ey -/GAOl