Suzuki GP125 - Page 30

Service limit 259.5 mm (10.22 in)
Cleaning and lubricating
Wash
the
drive
chain
in
cleaning
solvent
and
lubricate
it
with
chain
lube
or
motor
oil.
If
the
motorcycle
operates
under
dusty
conditions,
frequent
rapid
acceleration
or
at
sustained
high
speeds,
the
drive
chain
should
be
cleaned
and
lubricated
more
often.
Adjusting
* Loosen the adjuster (3) until the chain has 15 |
— 20 mm (0.6 — 0.8 in) of sag at the middle È
between engine and rear sprockets. The mark
4 on both chain adjusters must be at the
same position on the scale to ensure that the È
front and rear wheels are correctly aligned.
15
а 20 mm
04 06
0.8 in)
* After adjusting the drive chain, tighten the
axle nut 1) securely and lock with cotter pin -
2) . Always use a new cotter pin.
1
| 36—52Nm |
| Rear axle nut 38—52kgm |
tightening torque 260 sibi