Suzuki GP125 - Page 44

Drive plate distortion: Clutch springs
Clutch springs which have lost their tension also
cause clutch slipping, resulting in loss of power
қ and rapid wear of the clutch plates.
Remove the clutch springs and measure their
free length with calipers.
NOTE:
If one of them is longer than service limit,
renew all of them at a time.
Service
limit
0.4
mm
(0.016
in)
Driven plate distortion: K
NYI
Service
lini
33.6
mm
(1.32
in)
Clutch release bearing
Inspect this thrust-type bearing for any abnor.
mality, particularly cracks, upon removal from
Service
limit
0.1
mm
(0.004
in)
the
clutch,
to
decide
whether
it
can
be
reused
or
——.
should
be
replaced.
]
Smooth
engagement
and
disengagement
of
the
clutch depends much on the condition of this
bearing,