Suzuki GP125 - Page 72

55
CHECKING MAGNETO COILS
Use a SUZUKI pocket tester or an ohm meter
and check each coils for continuity.
Pocket tester 09900-25002 |
* CDI type (NIPPON DENSO)
[ Coil Resistance
| Highspeed (B - B/R) | Approx. 270
Low speed (B/R — R/B) | Approx. 2002 |
Charging (G/W - Ground) | Approx. 0.29 |
Lighting (Y — Ground)
Approx. 0.32
* CDI type (KOKUSAN)
Coil
Exciter (B/R — B/W)
[ Pulser (B/R — RW) Approx. 242
Charging (G/W — Y) ~ Approx. 0.22
Lighting (Y — Ground) Approx. 0.32
—]
| Resistance
Approx. 2102
* Point type (E-24 and E-35)
[coil | Resistance
| Primary (B/Y — Ground) | Approx. 0.19
Charging (М/А — Ground)| Approx. 0.22 |
Lighting (УЛУ — Ground) | Approx. 0.30
* Point type (for other)
Coil Resistance
| Primary (В/У — Ground) | Approx. 0.050
| Charging (М/Н — Ground)| Approx. 0.20
| Lighting (Y/W — Ground) | Approx. 0.29.
CONDENSER(For point type)
A condenser is connected parallel with the
contact points to minimize point arking. The
amount of charge the condenser can store is
determined by its capacity.
The capacity should be checked using an electro
tester.
* Insert insulation between the points and the
condenser body should be isolated from
ground.
© Set the tester selector knob to "MF".
©
Set
the
power
switch
to
“ON”
and
calibrate
the
multimeter
“D”
scale
to
the
“CAL”
posi
tion
using
the
"MF"
calibration
screw.
*
Connect
the
red
(positive)
lead
to
the
con.
denser
lead
and
the
black
(negative)
lead
to
the
condenser
case
mounting
tab.
©
Press
the
test
button
and
note
the
"D"
scale
reading.
If the reading does not fall within the stan.
dard range, replace the condenser.
Electro tester 09900-28106
STD condensor capacity range 1
NIPPON DENSO таке [0.18 + 0.02uF `
KOKUSAN DENKI make | 0.25 + 0.03yF