Suzuki GP125 - Page 82

REAR WHEEL REMOVAL
1, Remove muffler
Disconnect brake adjuster 1 and remove
torque link nut (2) after removing pin (3
4. Draw out wheel bearings.
INSPECTION
WHEEL BEARINGS
Visually inspect the wheel hub bore, from
which the bearings have been extracted, for
evidence of abnormal wear caused possibly by
spinning, if any, of bearing outer races.
Check the wheel bearings in the usual manner
after washing them, Make sure that the
bearings spin smoothly without any noise or
resistance: spin them with your fingers. Never
use an air gun for this purpose.