Fig 1
Fig 2
2
1
(B)
(D)
(A)
(C)
15mm
15mm
45mm
18mm18mm
PRECAUTIONS
FOR
INSTALLATION
INSTALLATION
201503
2 of 3
99000-9900A-04K
INSTALLATION
1.
2.
3.
4.
5.
6.
IMPORTANT
WARNING / CAUTION / NOTICE / NOTE
NOTE
:
Indicates special information to make maintenance easier or instructions clearer.
Indicates a potential hazard that could result in death or serious injury.
Indicates a potential hazard that could result in minor or moderate injury.
Indicates a potential hazard that could result in vehicle or equipment damage.
WARNING
CAUTION
NOTICE
Please read this manual and follow its instructions carefully. To emphasize special
information, the symbol and the words WARNING, CAUTION, NOTICE and NO-
TE have special meanings. Pay particular attention to messages highlighted by these
signal words.
Check that the kit has all the parts as listed in the "CONTENTS" section.
Check each part in the kit for scratches or any form of damage.
Park the vehicle on a level place.
Remove the ignition key from the switch and store it in a safe place.
Protect any items removed or to be installed from scratches by placing them on a soft
cloth first before putting them on the ground.
Use care not to cause any damage to the body of the vehicle during installation of the
accessory.
1.
Apply CUSHION ② in the backside of
METER VISOR ①. (Fig 1)
2.
NOTE：
Pay attention not to brake the connecting clip
upon removing Headlamp cover (B) and
Headlamp upper cover (C).
Remove Meter cover (A), Headlamp cover (B),
Headlamp upper cover (C) and Headlamp (D) according to
the service manual. (Fig 2)
To Next Page
Loading...
