ENGINE MECHANICAL (K9K ENGINE) 6A2-5
4) Install special tools (Oil pressure gauge) to vacated threaded
hole.
Special tool
(A): 09915-77311
(B): 09915-77420
(C): 09915-77430
5) Start engine and warm it up to normal operating tempera-
ture.
6) After warming up, measure oil pressure.
Oil pressure specification:
100 – 140 kPa (1.0 – 1.4 kg/cm
2
, 14.2 – 20.0 psi) at idle
speed
330 – 370 kPa (3.3 – 3.7 kg/cm
2
, 46.9 – 52.5 psi) at 3,000 r/
min
7) Stop engine and remove oil pressure gauge and attachment.
8) Reinstall oil pressure switch (1), and tighten switch to speci-
fied torque.
Tightening torque
Oil pressure switch (a): 35 N·m (3.5 kg-m, 25.5 lb-ft)
9) Connect oil pressure switch coupler (2).
10) Install degassing tank to its bracket.
11) Start engine and check oil pressure switch for oil leakage.
If oil leakage is found, repair it.
CAUTION:
Be careful not to make special tool touch exhaust mani-
fold when installing because exhaust manifold becomes
very hot.
(A)
(B)
(C)
NOTE:
Be sure to place transmission gear shift lever in “Neu-
tral” and set parking brake and block drive wheels.
1, (a)
2
To Next Page
Loading...
