2-158
BEFORE DRIVING
80SS5-01E
Wiper and washer operation
When the ignition switch is in “ON” position
or the ignition mode is ON, you can use
the wiper/washer lever.
When the wipers are under heavy load
such as covered by snow, the breaker will
be activated and the wipers will stop oper-
ating to protect the wiper motor from over-
heating. If the wiper stops during
operation, do the following methods.
1) Stop the vehicle in a safe place, and
turn the engine off.
2) Move the wiper lever and switch to
“OFF” position.
3) Remove obstacles such as snow on the
wipers.
4) After a while, when the temperature of
the wiper motor becomes low enough,
the breaker will be reset automatically
and the wipers will be able to use.
If you cannot use the wipers after a while,
there may be another problem. Ask an
authorized SUZUKI dealer to have the wip-
ers inspected.
Windshield wipers
68PM00237
To turn the windshield wipers on, move the
lever down to one of the three operating
positions. In “INT” position, the wipers
operate intermittently. The “INT” position is
very convenient for driving in mist or light
rain. In “LO” position, the wipers operate at
a steady low speed. In “HI” position, the
wipers operate at a steady high speed. To
turn off the wipers, move the lever back to
“OFF” position.
Move the lever up and hold it to “MIST”
position, the windshield wipers will turn on
continuously at low speed.
68PM00238
If the lever is equipped with “INT TIME”
control, turn the control knob forward or
backward to adjust the intermittent wiper
operation to the desired interval.
To Next Page
Loading...
Need help?
General
