7-54
INSPECTION AND MAINTENANCE
80SS5-01E
Continuously Variable
Transmission (CVT) fluid
Specified fluid
Use a CVT fluid SUZUKI CVT FLUID
GREEN-2.
Fluid level check
You must check the fluid level with the CVT
fluid at normal operating temperature.
To check the fluid level:
1) To warm up the CVT fluid, drive the
vehicle for more than 5 km (3 miles).
2) Then drive for ten more minutes.
NOTE:
Do not check the fluid level if you have just
driven the vehicle for a long time at high
speed, or if you have driven in city traffic in
hot weather. Wait until the fluid cools down
(about 30 minutes), or the fluid level indi-
cation will not be correct.
3) Park your vehicle on level ground.
4) Apply the parking brake and then start
the engine in “P” (Park). Let it idle for
two minutes and keep it running during
the fluid level check.
5) With your foot on the brake pedal,
move the gearshift lever through each
gear position, pausing for about three
seconds in each position. Then move it
back to “P” (Park) position.
NOTICE
Clutch fluid is supplied from brake
fluid reservoir. If your clutch fluid
level is increased or near the “MIN”
line, there is a possibility of clutch or
brake fluid leakage or abnormal wear
of clutch.
Have your vehicle inspected immedi-
ately by a SUZUKI dealer or a quali-
fied workshop.
NOTICE
Driving with too much or too little
fluid can damage the transmission.
NOTICE
Be sure to use the specified CVT
fluid. Using CVT fluid other than
SUZUKI CVT FLUID GREEN-2 may
damage the CVT of your vehicle.
WARNING
Be sure to depress the brake pedal
when moving the gearshift lever, or
the vehicle can move suddenly.
To Next Page
Loading...
Need help?
General
