3-22
OPERATING YOUR VEHICLE
80SS5-01E
For K14D engine models
*NOTE:
You may not accelerate to the maximum
allowable speed because of the driving sit-
uation and/or the vehicle condition.
6-Speed automatic transmission
Gearshift lever
52RM30250
The gearshift lever is designed so that it
cannot be shifted out of “P” position unless
the ignition switch is in “ON” position or the
ignition mode is ON and the brake pedal is
depressed.
Use the gearshift lever positions as fol-
lows:
P (Park)
Use this position to lock the transmission
when the vehicle is parked or when start-
ing the engine. Shift into Park only when
the vehicle is completely stationary.
R (Reverse)
Use this position to reverse the vehicle
from stop. Make sure that vehicle is com-
Downshifting km/h (mph)
2nd to 1st 20 (12)
3rd to 2nd 85 (52)
4th to 3rd 130 (80)
5th to 4th 175 (108)*
6th to 5th 210 (130)*
NOTICE
Do not downshift to a lower gear at
the speed faster than the maximum
allowable speeds for the next lower
speed, or severe damage to engine
and transmission can result.
WARNING
• Reduce your speed and downshift
to a lower gear before going down
a long or steep hill. A lower gear
will allow the engine to provide
braking. Avoid riding the brakes or
they may overheat, resulting in
brake failure.
• When driving on slippery roads,
slow down before downshifting.
Excessive and/or sudden changes
in engine speed may cause loss of
traction, which could cause you to
lose control.
NOTICE
Check that the vehicle is completely
stationary before you shift into
reverse.
NOTICE
• To help avoid clutch damage, do
not use the clutch pedal as a foot-
rest while driving or use the clutch
to keep the vehicle stationary on a
slope. Depress the clutch fully
when shifting.
• When shifting or starting off, do not
race the engine. Racing the engine
can shorten engine life and cause
negative effect to smooth shifting.
To Next Page
Loading...
Need help?
General
