3-47
OPERATING YOUR VEHICLE
80SS5-01E
Conditions to stop the engine automatically
If all of the following conditions are met while the standby conditions are met, the engine is stopped automatically when the vehicle is
decelerating before stopping or when the vehicle is stopped.
#: The engine may not be stopped automatically if the brake pedal was depressed lightly or strongly.
When decelerating
before stopping
Manual
transmis-
sion
• The clutch pedal is depressed, the gearshift lever is shifted into “N” position, and then the
clutch pedal is released when the vehicle speed is approximately 15 km/h (9 mph) or less.
CVT
• The ABS or ESP
®
system has not been activated.
• Brake booster vacuum pressure is normal.
• The brake pedal is sufficiently depressed. (#)
• The vehicle is decelerating to a speed of approximately 13 km/h (8 mph) or less.
• The accelerator pedal is not depressed.
• The vehicle is not being driven on a steep hill.
• The brake is not applied abruptly.
When the vehicle is
stopped
Manual
transmis-
sion
• The gearshift lever is in “N” position.
• The clutch pedal is released.
CVT
• The ABS or ESP
®
system has not been activated.
• Brake booster vacuum pressure is normal.
• The brake was not applied abruptly before the vehicle was stopped.
• The brake pedal is sufficiently depressed. (#)
• The accelerator pedal is not depressed.
• The vehicle is not stopped on a steep hill.
To Next Page
Loading...
Need help?
General
