3-95
OPERATING YOUR VEHICLE
80SS5-01E
(5) Following distance indicator
(6) Adaptive cruise control indicator
(7) “SET” indicator
(8) Vehicle ahead detecting indicator
(9) Set speed indication
1) Turn on the adaptive cruise control sys-
tem by pushing cruise switch (2). When
the adaptive cruise control indicator (6),
and following distance indicator (5)
come on or appear in the information
display, you can set cruising speed.
2) Accelerate or decelerate to the desired
speed.
3) Pull down the “RES +/SET –” switch
(4), “SET” indicator (7) and set speed
indication (9) appears in the information
display.
Take your foot off the accelerator pedal
and the set speed will be maintained. At
this time, vehicle ahead detecting indi-
cator (8) will vary as follows, depending
on the presence or absence of the vehi-
cle ahead.
B TYPE
CLUSTER METER
C TYPE
CLUSTER METER
A vehicle ahead is not detected. In this
case, your vehicle is in the state of con-
stant-speed control.
B TYPE
CLUSTER METER
C TYPE
CLUSTER METER
A vehicle ahead is detected. In this case,
your vehicle is in the state of deceleration
control and following control.
WARNING
If the cruising speed is accidentally
set, you could lose control of the
vehicle. This could lead to an acci-
dent, resulting in severe injury or
death.
Turn off the adaptive cruise control
system and check that the adaptive
cruise control indicator (6) disap-
pears when the system is not in use.
To Next Page
Loading...
Need help?
General
