3-97
OPERATING YOUR VEHICLE
80SS5-01E
Changing speed temporarily
When the cruising speed is maintained,
you can temporarily accelerate or deceler-
ate.
To accelerate, depress the accelerator
pedal. When you take your foot off the
pedal, your vehicle will return to the set
speed.
To decelerate, depress the brake pedal.
The set speed will be canceled and “SET”
indicator (7) will disappear. To resume the
previously set speed, pull up the “RES +/
SET –” switch (4) and turn on “SET” indica-
tor (7) again when vehicle speed is above
about 40 km/h (25 mph). The vehicle will
accelerate to the previously set speed and
maintain its speed.
Changing cruising speed
Using the accelerator pedal
To reset at a faster cruising speed, acceler-
ate to the desired speed using the accelera-
tor pedal and pull down the
“RES +/SET –”
switch (4). The new speed will be main-
tained.
Using the brake pedal
To reset at a slower cruising speed, decel-
erate to the desired speed using the brake
pedal and pull down the “RES +/SET –”
switch (4). The new speed will be main-
tained.
NOTE:
When the brake pedal is depressed, “SET”
indicator (7) disappears until you reset the
cruising speed.
Using “RES +/SET-” switch
To reset at a faster cruising speed, press
repeatedly or hold pulling up the “RES +/
SET –” switch (4). Vehicle speed will
steadily increase. When you release the
switch, the new speed will be maintained.
To reset at a slower cruising speed, press
repeatedly or hold pulling down the “RES
+/SET –” switch (4).
NOTE:
• You can adjust the set speed by 1 km/h
(or 1 mph) by pulling up and down “RES
+/SET –” switch (4) quickly.
• You can adjust the set speed by 5 km/h
(or 5 mph) by pulling up and down and
holding “RES +/SET –” switch (4).
(e.g. 62 Km/h (or 42 mph) > 65 Km/h (or
45 mph) > 70 Km/h (or 50 mph), etc)
• While deceleration control or following
control is activated, the vehicle is not
accelerated even though resetting to
higher cruising speed by continuous
pulling up the “RES +/SET –” switch (4)
is operated. However, if the vehicle
ahead disappears, the vehicle is accel-
erated automatically to the set speed.
To Next Page
Loading...
Need help?
General
