5-18
OTHER CONTROLS AND EQUIPMENT
80SS5-01E
Air intake selector (3)
52RM50310
This selector is used to select the following
modes.
FRESH AIR (a)
When this mode is selected by moving the
lever to left, outside air comes in.
RECIRCULATED AIR (b)
When this mode is selected by moving the
lever to right, outside air is shut out and
inside air is recirculated. This mode is suit-
able when driving through dusty or polluted
air such as in a tunnel, or when attempting
to quickly cool down or warm up the inte-
rior.
NOTE:
If you select RECIRCULATED AIR for an
extended period of time, the air in the vehi-
cle can become contaminated and the win-
dows tend to get misted. Therefore, you
should select FRESH AIR whenever possi-
ble.
52RS50181
NOTE:
The mark of “ ” (6)
To clear fog on the windshield and/or the
side windows quickly, set the air flow
selector (4) to HEAT & DEFROST or
DEFROST and air intake selector (3) to
FRESH AIR. These positioning will clear
the fogged windshield and/or the side win-
dows faster than the RECIRCULATED
AIR.
Air flow selector (4)
52RM50250
This is used to select one of the following
functions.
VENTILATION (c)
52RS50020
Temperature-controlled air comes out of
the center and side air outlets.
To Next Page
Loading...
Need help?
General
