8-10
EMERGENCY SERVICE
80SS5-01E
81PN248
5) Remove the plug from the filler hose (3)
and insert the filler hose into the tyre
valve (8).
63J349
6) Hold the bottle (2) with bottom upwards
and pump the bottle to fill the entire bot-
tle contents (sealant) into the tyre.
Thereafter pull off the filler hose and
firmly screw the valve insert into the
tyre valve again. If the valve insert is
dirty or lost, use the enclosed spare
valve insert.
81PN120
7) Screw the air hose (10) of the compres-
sor (1) to the tyre valve (8). Fit the
power plug (11) to the accessory
socket. For a manual transmission
vehicle, shift from “R” (Reverse) into “N”
(Neutral). Start the engine. Switch on
the compressor. Inflate the tyre to the
required air pressure.
(3)
(8)
WARNING
Do not stand by the tyre, when inflat-
ing. It can burst.
NOTICE
Do not operate the compressor for
longer 10 minutes without cease. It
can cause overheating of the com-
pressor.
(1)
(8)
(11)
(10)
10 min. Max.
required
air pressure
To Next Page
Loading...
Need help?
General
